Vol. 11 No. 04 (2021): Journal of Materials & Construction
##common.pageHeaderLogo.altText##
Tạp chí Vật liệu & Xây dựng - Bộ Xây dựng

ISSN:

Website: www.jomc.vn

Study on geopolymer concrete based fly ash and slag of thermal plant and foam agent H2O2

Tuan Le Anh , Thuy Nguyen Ninh , Khoa Nguyen Tan

Keywords:

Fly ash
Bottom ash
Hydrogen peroxdie
Foam agent
Geopolymerization

Abstract

In this research, geopolymer mortar is investigated by mixing fly ash and bottom ash with hydrogen peroxide (H2O2) to activate in geopolymerization. In the mix proportion, the amount of bottom ash in range from 20 to 100 % by weight is investigated. The results are indicated that the flow diameters are increased up to 70 % by mixing alkaline solution in range from 0.4 to 0.8 by fly ash weight. Moreover, strengths are raise up to 50 %. On the other hand, the flow diameter and flow time are tend to increase up to 30 % and obtained 10 – 11 sec, respectively, by replacement of bottom ash in rangs from 20 to 100 % by sand weight. However, strength is tend to reduce about 40 %. In the mix proportion, hydrogen peroxide (H2O2) is used as foam agent in range from 1 to 5 % by volume. The expansion degrees are obtained tp to 40 % by foam agent. After curing condition, the strength of concrete can be obtained by amount of foam agent and alkaline solution. Then, light weight geopolymer concrete can be produced by mixing fly ash, bottom ash and H2O2 agent to geopolymerization.

User Navigation

PDF (Tiếng Việt)

How to Cite

Le Anh, L. A., Nguyen Ninh, N. N. ., & Nguyen Tan, N. T. . (2021). Study on geopolymer concrete based fly ash and slag of thermal plant and foam agent H2O2. Tạp Chí Vật liệu & Xây dựng - Bộ Xây dựng, 11(04), Trang 6 – Trang 12. https://doi.org/10.54772/jomc.04.2021.145

References

  1. . K. C. Brady, G. R. A. Watts, and M. R. Jones, (2001) Specification for Foamed Concrete, UK: Highway Agency.
  2. . Z. Li (2011), Advanced Concrete Technology, Hoboken, New Jersey: John Wiley & Sons, pp. 219-220.
  3. . E. K. K. Nambiar and K. Ramamurthy,(2006) “Influence of filler type on the properties of foam concrete,” Cement and Concrete Research, vol. 28, pp. 475–480.
  4. . K. Ramamurthy, E. K. K. Nambiar, and G. I. S. Ranjani, (2009) “A classification of studies on properties of foam concrete,” Cement and Concrete Composites, vol. 31, no. 6, pp. 388–396.
  5. . Cui, Y. L., Qian, F. G., Liu, S. X., & Yin, H. T. (2014). Effects of Hydrogen Peroxide on Foam Concrete Performances. Applied Mechanics and Materials, 584–586, 1746–1749.
  6. . World of Coal Ash (2013), World of Coal Ash Conference in Kentucky
  7. . Klaus Rennings and Wilko Smidt (2010) A Lead Market Approach towards the Emergence and Diffusion of Coal-Fired Power Plant Technology, Economia Politica XXVII(2):303-328.
  8. . Kim, Y., Dang, M.Q. & Do, T.M. (2016) Studies on compressive strength of sand stabilized by alkali-activated ground bottom ash and cured at the ambient conditions. Geo-Engineering 7, 15.
  9. . Chou MI.M. (2012) Fly Ash. In: Meyers R.A. (eds) Encyclopedia of Sustainability Science and Technology. Springer, New York.
  10. . Davidovits (1994), Properties of Geopolymer cement, Proceding first International conference on Akaline cements and concretes, pp. 131-149.
  11. . H. Xu, J.S.J. van Deventer (2000), The geopolymerisation of alumino-silicate minerals, International Journal of Mineral Processing, vol.59, pp. 247-266.
  12. . J. Davidovits (2011), Geopolymer Chemistry and Applications, Saint-Quentin, France, Geopolymer Institute.
  13. . Kim HK (2015) Utilization of sieved and ground coal bottom ash powders as a coarse binder in high-strength mortar to improve workability. Constr Build Mater 91:57–64
  14. . D. M. S. P. Dassanayake and S. M. A. Nanayakkara, (2018) "Development of Geopolymer with Coal Fired Boiler Ash," 2018 Moratuwa Engineering Research Conference (MERCon), Moratuwa, pp. 356-361.