##common.pageHeaderLogo.altText##
Tạp chí Vật liệu & Xây dựng - Bộ Xây dựng

ISSN:

Website: www.jomc.vn

Prediction of shear capacity of concrete beams reinforced with FRP bars

Phuong Nguyen Viet , Phuong Nguyen Ngoc , Hiep Dang Vu

Abstract

Currently, Fiber-reinforced polymer (FRP) bars have gained the popupar acceptance as an alternative to conventional steel bars for concrete members due to their corrosion resistance, high strength against low weight, magnetic immunity. Therefore, predicting the strength capacity of such members, particularly the shear capacity is one of the most important issues in design. In this paper, the prediction method and assessment of the shear strength of concrete beams reinforced with FRP bars according to three codes ACI 440.1R-06, CSA S806-02 and JSCE-1997 is presented. The paper then proposes a simple formula to predict the shear strength for FRP bar-reinforced concrete beams. The predicted values are compared with 73 experimental results obtained from previously published researches. The results indicate that the design codes are relatively conservative with large coefficients of variation, while the proposed equation gives results that are in better agreement with the experimental results and a lower coefficient of variation.

References

  1. Bentz, E.C., L. Massam, and M.P. Collins, Shear Strength of Large Concrete Members with FRP Reinforcement. Journal of Composites for Construction, 2010. 14(6): p. 637-646.
  2. Issa, M.A., T. Ovitigala, and M. Ibrahim, Shear Behavior of Basalt Fiber Reinforced Concrete Beams with and without Basalt FRP Stirrups. Journal of Composites for Construction, 2016. 20(4): p. 04015083.
  3. Jumaa, G.B. and A.R. Yousif, Size effect on the shear failure of high-strength concrete beams reinforced with basalt FRP bars and stirrups. Construction and Building Materials, 2019. 209: p. 77-94.
  4. Huy, Đ.T., Nghiên cứu khả năng chịu cắt của dầm bê tông cốt sợi thủy tinh, Luận văn thạc sỹ kỹ thuật, 2015, Đại học Kiến Trúc Hà Nội.
  5. Razaqpur, A.G. and S. Spadea, Shear Strength of FRP Reinforced Concrete Members with Stirrups. Journal of Composites for Construction, 2015. 19(1): p. 04014025.
  6. Kueres, S. and J. Hegger, Variable strut inclination model for shear design of FRP reinforced concrete members with shear reinforcement. Engineering Structures, 2020. 206: p. 110154.
  7. Rovnak, M. and L. Nguyen-Minh, Shear resistance of GFRP-reinforced concrete beams. Magazine of Concrete Research, 2011. 63: p. 215-233.
  8. Hoult, N.A., et al., Does the Use of FRP Reinforcement Change the One-Way Shear Behavior of Reinforced Concrete Slabs? Journal of Composites for Construction, 2008. 12(2): p. 125-133.
  9. ACI (American Concrete Institute), Guide for the Design and Construction of Structural Concrete Reinforced with FRP Bars, ACI 440.1R-06, 2006, Farmington Hills, MI.
  10. CSA (Canadian Standards Association), Design and construction of building components with fiber-reinforced polymers, CAN/CSAS806-02, 2002: Mississauga,ON, Canada.
  11. Japan Society of Civil Engineers (JSCE), Recommendation for design and construction of concrete structures using continuous fiber reinforcing materials, 1997: Research Committee on Continuous Fiber Reinforced Material, Tokyo
  12. TCVN 5574-2018, Kết cấu bê tông và bê tông cốt thép – tiêu chuẩn thiết kế, 2018: Bộ Xây Dựng Hà Nội.
  13. Noor Azlina A. Hamid, et al., Shear Strength Prediction for Concrete Beams Reinforced with GFRP Bars. ISCEE 2016.
  14. Abu-Obaida, A., B. El-Ariss, and T. El-Maaddawy, Behavior of Short-Span Concrete Members Internally Reinforced with Glass Fiber-Reinforced Polymer Bars. Journal of Composites for Construction, 2018. 22(5).
  15. Ashour, A.F. and I.F. Kara, Size effect on shear strength of FRP reinforced concrete beams. Composites Part B: Engineering, 2014. 60: p. 612-620.
  16. Tottori S and Wakui H, Shear capacity of RC and PC beams using FRP reinforcement. In: Fiber-reinforced-plastic reinforcement for concrete structures, SP-138. Detroit: American Concrete Institute, 1993: p. 615–32.
  17. P. Bamforth, et al., Properties of Concrete for use in Eurocode 2. The Concrete Centre, 2008.
  18. Building Code Requirements for Structural Concrete (ACI 318-19), Reported by ACI Committee 318.
  19. CSA “Design of concrete structures”, Standard A23.3-04.

Most read articles by the same author(s)

1 2 > >>