ISSN:
Website: www.jomc.vn
Phương pháp thiết kế cải tiến cho kết cấu móng đường sắt sử dụng đá balast
Tóm tắt
Nghiên cứu trình bày cách tiếp cận thiết kế kết cấu móng đường sắt có đá ba lát, hướng đến áp dụng cho các dự án đường sắt hiện đại tại Việt Nam dưới tác dụng của tải trọng lặp lớn, tốc độ khai thác cao và điều kiện nền đất yếu không đồng nhất. Phương pháp kết hợp các quan hệ thực nghiệm về biến dạng dẻo tích lũy của đá ba lát và đất nền với mô hình phần tử hữu hạn 3D (3D FE) để đánh giá ứng xử hệ thống ray – tà vẹt – đá ba lát – nền đường. Hai tiêu chí thiết kế được xem xét gồm phá hoại cắt tiến triển bề mặt nền và biến dạng dẻo tích lũy. Phân bố ứng suất lệch từ mô hình số là cơ sở đánh giá ảnh hưởng của chiều dày, độ cứng và đặc trưng vật liệu, phục vụ xây dựng biểu đồ thiết kế và định hướng hiệu chỉnh phù hợp điều kiện thực tế tại Việt Nam.
Tài liệu tham khảo
- J. E. D. Alva-Hurtado, “A methodology to predict the elastic and inelastic behavior of railroad ballast,” Ph.D. dissertation, Dept. of Civil Engineering, University of Massachusetts, Amherst, MA, USA, 1980.
- G. P. Raymond and D. R. Williams, “Repeated load triaxial tests on a dolomite ballast,” Journal of the Geotechnical Engineering Division, ASCE, vol. 104, no. 7, pp. 1013–1029, 1978, doi: 10.1061/AJGEB6.0000655.
- J. Lackenby, B. Indraratna, G. McDowell, and D. Christie, “Effect of confining pressure on ballast degradation and deformation under cyclic triaxial loading,” Géotechnique, vol. 57, no. 6, pp. 527–536, 2007, doi: 10.1680/geot.2007.57.6.527.
- D. Li, “Railway track granular layer thickness design based on subgrade performance under repeated loading,” Ph.D. dissertation, Dept. of Civil Engineering, University of Massachusetts, Amherst, MA, USA, 1994.
- D. Li and E. T. Selig, “Cumulative plastic deformation for fine-grained subgrade soils,” Journal of Geotechnical Engineering, ASCE, vol. 122, no. 12, pp. 1006–1013, 1996, doi: 10.1061/(ASCE)0733-9410(1996)122:12(1006).
- D. Li and E. T. Selig, “Resilient modulus for fine-grained subgrade soils,” Journal of Geotechnical Engineering, ASCE, vol. 120, no. 6, pp. 939–957, 1994.
- M. A. Sayeed and M. A. Shahin, “Modelling of ballasted railway track under train moving loads,” in Proc. 12th Australia–New Zealand Conference on Geomechanics, Wellington, New Zealand, 2015, pp. 1–8.
- M. A. Sayeed and M. A. Shahin, “Three-dimensional numerical modelling of ballasted railway track foundations for high-speed trains with special reference to critical speed,” Transportation Geotechnics, vol. 6, pp. 55–65, 2016, doi: 10.1016/j.trgeo.2016.01.003.
- M. A. Sayeed and M. A. Shahin, “Investigation into impact of train speed for behavior of ballasted railway track foundations,” Procedia Engineering, vol. 143, pp. 1152–1159, 2016, doi: 10.1016/j.proeng.2016.06.131.
- A. M. Kaynia, C. Madshus, and P. Zackrisson, “Ground vibration from high-speed trains: Prediction and countermeasure,” Journal of Geotechnical and Geoenvironmental Engineering, ASCE, vol. 126, no. 6, pp. 531–537, 2000, doi: 10.1061/(ASCE)1090-0241(2000)126:6(531).
- H. Takemiya, “Simulation of track–ground vibrations due to a high-speed train: The case of X-2000 at Ledsgard,” Journal of Sound and Vibration, vol. 261, no. 3, pp. 503–526, 2003, doi: 10.1016/S0022-460X(02)01007-6.
- M. A. Sayeed and M. A. Shahin, “Design of ballasted railway track foundations using numerical modelling. Part I: Development,” Canadian Geotechnical Journal, vol. 55, no. 3, pp. 353–368, 2018, doi: 10.1139/cgj-2016-0633.
- M. A. Sayeed and M. A. Shahin, “Design of ballasted railway track foundations using numerical modelling. Part II: Applications,” Canadian Geotechnical Journal, vol. 55, no. 3, pp. 369–396, 2018, doi: 10.1139/cgj-2016-0634.
- J. E. D. Alva-Hurtado and E. T. Selig, “Permanent strain behavior of railway ballast,” in Proc. 10th International Conference on Soil Mechanics and Foundation Engineering, Stockholm, Sweden, 1981, pp. 543–546.
- J. E. D. Alva-Hurtado, D. R. McMahon, and H. E. Stewart, “Apparatus and techniques for static triaxial testing of ballast,” in Laboratory Shear Strength of Soils, ASTM STP 740, R. N. Yong and F. C. Townsend, Eds. Philadelphia, PA, USA: ASTM, 1981, pp. 94–113, doi: 10.1520/STP28746S.

